 |
|
8210
Lankershim Blvd. #14 /North Hollywood, CA 91605 (818) 768-2880
(818) 768-4808 fax
Professional service from behind the scenes since 1980. |
 |
 |
FX011
SHATTERING DOG
TACO BELL commercial. Brent Thomas, director.
Specifications:
Multiple 18" tall, eggshell thin, pre-scored Chihuahua body doubles shattered
with rake wire pulls and individual, time lapse monofilament pulls.
Materials:
Urethane, monofilament and spider wire.
The big challenge of this shatter effect was our clients'request to have our Chihuahua crack/shatter completely first, then have all the pieces fall to the ground. Starting with eggshell thin castings, heavily pre-scored in small triangle patterns, we experimented with a lot of different approaches- a pyro shockwave from above, an air-ram shockwave from below, different types of wire pulls, a rake arm, and even one by one piece removal. Using primer cord, we were able to achieve the pyro without smoke, but the Pyro still gave off a flash that could not be removed. The air ram shockwave was promising, but dissipated too much before reaching and affecting the head enough.
Substituting sugar glass for the prescored castings was not able to increase the reach of the shockwave into our Chihuahua form. Wire pulls also could not achieve enough small pieces. A combination air ram shockwave and simultaneous downward wire pull was an improvement but unable to create small enough pieces. A rake arm pulled down from outside the piece tended to pop too many pieces outward, revealing the source of the shatter. The same with a rapid air cannon filled, green-screen balloon pop. The best approach turned out to be a combination of a few of these techniques. We cross-threaded fishing line back & forth through the pre-scored small triangle pattern cuts , weaving fishing line throughout the interior of the prescored bodies. A rake arm was then ripped downward from inside the dog, through the cross-threaded wires. This was pretty dramatic but stiil needed improvement- the head was still not coming apart enough.
The solution was found by shooting individual piece by piece pulls, one at a time, from the top down, and compositing these together with the wire-rake pull footage. Film was shot at high speed to thoroughly capture every detail in every step of these split-second performances. In-Site-Pix (www.insitepix.com), who we've worked together with so successfully in the past, did all the composite assembly work.
©2001 Anatomorphex
ALL RIGHTS RESERVED
www.anatomorphex.com